Section 2 - Pair If you've followed those instructions exactly, have gone through the troubleshooting tips, and still have an issue, I got nothing. To change this number hold the magnet to the tip of the sensor fig. Cycle Mode to the four-digit number. Removing the computer from the computer baseThe computer is held on its base by a flexible snap. The trip meter also appears to be very accurate. The altimeter is usesless, it never gives the same elevation despite returning repeatedly to the same place.
The instructions are not easy to follow and in use the computer is not intuitive e. Select the bar clamp that fits your bike. Mark the new location of the valve stem. Lift the front wheel off the ground and spin the wheel checking if current speed is displayed. Cycle Set to the minute. Spoke Channel Spoke Screw Odometer total distance 0.
I have an old 2 button Trek Sensor cyclometer. These data are all erased when the Trip Data is erased. Ha ha, I'm not a techy and also not patient but I will try again. Repeat steps 4 and 5 until all digits have been set. It may be possible to shake the battery out. ReStart sets only the Trip data to zero.
Make sure the computer wire is not pulled tight when the handlebar is turned all the way to either side. It has not been the most user friendly computer and the instructions don't help much. We recommend setting the speed scale and wheel circumference before installing the computer. Displayed in hours, minutes, and seconds. The main thing I was looking for was a computer that could have a wireless speed and cadence sensor attached to the rear chain stay. In order to install smoothly, please take off the computer from the bracket temporarily.
Check the following before taking unit for repair. Thanks for the link to the instructions! If you do not understand the. Identify the battery cover, with its deep slot a similar battery cover is found on the back, or skin-side, or the heart rate strap. Extra wire length can be diverted by wrapping it around the brake housing prior to routing it down the fork blade or down tube Figure 8. Question About Trek Bicycle Accessories Trek Sensor 2 button Original Trek Sensor 2 button.
To attach the computer wire1. Place the battery properly into the case and close the cover securely. If you can only measure in inches, convert to millimeters by multiplying by 25. Make the wheel sensor send a signal spin the bicycle wheel. ReStart sets only the Trip data to zero.
Install the zip tie through wheel sensor and pull tight. Here is a table showing some possible problems, causes, andsolutions:Table 4- Common problems and solutionsBlank screenComputer is in shipping mode. It has not been the most user friendly computer and the instructions don't help much. If the Mode button is called out in the directions without specifying which one, you maypush either one and the computer will accordingly scroll in a different direction. Remove the battery cover by using a narrow flat blade or similar opener as illustrated in fig.
Cycle Set to 12 or 24 hour clock. To move within that function, removing the computer from the computer base The computer is held on its base by a flexible snap. These owner's manuals are meant to supplement any manual included with your Bontrager product. To install the computer on handlebar 1. I can change from Km to M. Please read this manual carefully and save it for future reference.