Use extra caution at intersections, parking entrances and exits and driveways. Reinstall the fuel tank using the procedures in the Service Manual. Remove and retain the hex socket head screw 4 at the top left of the bracket For 2007 models: In addition, disconnect the ground wire. · Left and right passenger foot rests. For 2007 models: In addition, remove the lower voltage regulator cover 10. In this way we have been able to optimize partial load behavior as well as throttle response.
· Left and right passenger foot rests. How to start and stop the engine, shif t gears, and brake. Remove and discard the voltage regulator caddy cover 6 from the regulator bracket 3 and caddy 5. Install Canister and Regulator with supplied hardware. Important saf ety inf ormation you should know, plus a look at the saf ety- related labels on your motorcycle. Removal of Original Parts Secure and raise the motorcycle 9 to 10 inches using a quality motorcycle lift.
No part of this publication may be reproduced without written permission. If you have any questions, or if you ever need special service or repairs, remember that your Honda dealer knows your motorcycle best and is dedicated to your complete satisfaction. . I'll gladly send it to you but I got mine direct from the Honda site as indicated above. Remove the caddy from the vehicle frame.
Wow, I did not know that, I have already downloaded the one from this site, and it has been extremely helpful. Please take a few moments to read these pages. Replace the diaphragm, spring, cover, and screws with new parts included in the kit. Like an airplane, a pre-ride inspection and regular maintenance are essential to your safety. This section also includes inf ormation about the location of safety labels on your motorcycle. This inf ormation alerts you to potential hazards that could hurt you or others. The result of this comprehensive development work is superior handling, improved rideability and lower fuel consumption.
Of course, it is not practical or possible to warn you about all hazards associated with operating or maintaining a motorcycle. For 2007 models: Unfasten the four-way 7 and two-way 8 voltage regulator connectors from the T-studs on the back of the regulator bracket 3 , and discard the bracket. See figure on the right. Clean cut frame and paint black. Drain the fuel into an approved container. Free the cable straps 9 from the regulator bracket, beneath the regulator. Inf ormation on warranties, emission controls, how to get Honda service manuals, and.
Download the Service Manual from this site. Remove and save the regulator, but discard the screws. Remove and secure Charcoal Canister. A Service Manual for your model motorcycle is required for this installation and is available from a Harley-Davidson Dealer. Torque lower 8mm bolts to 20 lb.
The new lower longitudinal strut is now made of aluminum and is thus considerably lighter. Most countries require a special riding test or license. Do not tighten the bolts until the backrest is assembled with the brackets Install the brackets and backrest. This instruction sheet references Service Manual information. Handy f acts about f uel, engine oil, tire sizes, and air pressures.
To make it easy to use, the manual contains a detailed list of topics at the beginning of each section, and both an in-depth table of contents and an index at the back of the book. Wear clothing that fully covers your legs. A passenger needs the same protection. The K Series model revision also heralds a new and innovative generation of switches and controls. Crank position sensor connector 2007 only Voltage regulator caddy 6. Voltage regulator caddy cover Horn connectors some 2008 and later models 7.